User: Password:
   Keep me logged in.
Register  |  I forgot my password
My Account
Pages
Statistics
  • Active Links: 6205
  • Pending Links: 808
  • Todays Links: 10
  • Active Articles: 450
  • Pending Articles: 322
  • Todays Articles: 6
  • Total Categories: 13
  • Sub Categories: 688
Check This Out!

DeepLnkPro 180x180

LinkShade DirectoryArticle Details

Sound Level Meter

Date Added: June 25, 2010 10:10:00 AM
Author: Varalakshmi
Category: Blogs: Business

Sound Level Meters measure sound pressure level and are commonly used in noise pollution studies for the quantification of almost any noise, but especially for industrial, environmental and aircraft noise. However, the reading given by a sound level meter does not correlate well to human-perceived loudness; for this a loudness meter is needed. The current International standard for sound level meter performance is IEC 61672:2003 and this mandates the inclusion of an A-frequency-weighting filter and also describes other frequency weightings of C and Z (zero) frequency weightings. The older B and D frequency-weightings are now obsolete and are no longer described in the standard. In almost all countries, the use of A-frequency-weighting is mandated to be used for the protection of workers against noise-induced deafness. The A-frequency curve was based on the historical equal-loudness contours and while arguably A-frequency-weighting is no longer the ideal frequency weighting on purely scientific grounds, it is nonetheless the legally required standard for almost all such measurements and has the huge practical advantage that old data can be compared with new measurements. It is for these reasons that A-frequency-weighting is the only weighting mandated by the international standard, the frequency weightings 'C' and 'Z' being optional fitments. Originally, the A-frequency-weighting was only meant for quiet sounds in the region of 40 dB sound pressure level (SPL), but is now mandated for all levels. C-frequency-weighting however is still used in the measurement of the peak value of a noise in some legislation, but B-frequency-weighting - a half way house between 'A' and 'C' has almost no practical use. D-frequency-weighting was designed for use in measuring aircraft noise, when non-bypass jets were being measured and after the demise of Concord, these are all military types. For all civil aircraft noise measurements A-frequency-weighting is used as is mandated by the ISO and ICAO standards. http://www.ipfonline.com/products/index/sound_level_meter_17 http://www.ipfonline.com/products/index/digital_sound_level_meter_4 http://www.ipfonline.com/products/index/sound_level_meter_18 http://www.ipfonline.com/products/index/sound_level_meter_15

 
Ratings Average rating: (0 votes)
You must be logged in to leave a rating.
Comments

No Comments Yet.


You must be logged in to leave a Comment.